Water Pump Rebuilding and Starter Generator Removal 1925 Buick by Hugh Leidlein 11-5-19 Water Pump Assembly removal Both the rear shaft coupling need to slide forward, and the front shaft bushing need

-- Short Tours over the Alps – 1918 E-45 Buick Due to time constraints I only did 2 smaller tours with my BUICK E-6-45, 1918, one of them, of course, again over the Alps. This time it was the Timmelsj

I was just thinking that maybe I could suggest an opportunity for everyone to expand their horizons, at least on-line, and to suggest some other sites that may be of interest. These are all sites that

Hello, This email message is a notification to let you know that the following files have been uploaded to the Files area of the PBR@BrassBuicks.groups.io group. /1924-25 Buick Info./24 Buick Heat Con

It looks like Kanter only supplies bearings for 1934 40 series. Are there suppliers for 50 series? Mike Martin Stanwood WA

Hello, This email message is a notification to let you know that the following files have been uploaded to the Files area of the PBR@BrassBuicks.groups.io group. /Marvel Carb Manual.pdf Uploaded By: M

To: John Forster <prewarbuicks@...> Cc: Peter Stone <peters@...> Good morning pre-war readers Peter Stone is seeking a set of windscreen posts for a 1928 master sports tourer. If you are able to assis

Enjoy the holidays as best you can this year. And, please stay safe to enjoy some Buick touring next year! Mark Shaw PBR List Owner Vancouver WA USA

-- Hugh Leidlein Lake Jackson TX USA

-- Hugh Leidlein Lake Jackson TX USA

-- Hugh Leidlein Lake Jackson TX USA

-- Hugh Leidlein Lake Jackson TX USA

This one is bigger than the others -- Hugh Leidlein Lake Jackson TX USA

Attached are pdf files of basically all the wood (except in the doors) used in the body of a 1925 Buick Standard model 25. These can be printed at an office supply store like Office Max or Staples "fu

Going to attempt to post the power points (There are 3) of the wood assembly and installing it inside the sheetmetal of a 1925 Buick Standard Touring. These are large files so be patient as they take

This powerpoint explains the body mounts used between the wood frame on the 1925 Buick and the metal frame of the chassis. -- Hugh Leidlein Lake Jackson TX USA

Most Starter Generator (SG) parts” are shared for 1923 -1925 6 cylinder cars. The 1922-24 4 cylinder cars share a grouping of parts as well. 1925 is the last year for the Delco SG units in Buicks. Att

How do I remove the horn button so that I can replace the wire that goes down the steering column? -- Mike Martin Stanwood WA USA

https://youtu.be/lD7XT0DtOmw Mark Shaw PBR List Owner Vancouver WA USA

DELCO-REMY DISTRIBUTOR 663-Y REBUILD (Step-By-Step photo guide to the 663-(?) Distributors) - Buick - Pre War - Antique Automobile Club of America - Discussion Forums (aaca.org) -- Mark Shaw PBR List